Sentence examples for bottom loading from inspiring English sources

During the BTS test, the constant displacement increment of 1 m/s is applied on both the top and bottom loading plates in the vertical direction but both the top and bottom loading plates are fixed in the horizontal direction.

Fig. 2 Stress-strain curves of the defect-free MoS2 sheet obtained from the armchair (top) and zigzag (bottom) loading.

To minimize size effects, a diameter of 5%% of the concrete cylinder was selected as the strip width for both the top and bottom loading points.

As the top and bottom loading plates contact the rock specimen, high stress concentrations are induced at the loading areas (Fig. 4a-A).

As shown in Fig. 6, the bearing failure did not occur at the whole bar-tube interfaces, because the NSC core was compressed by the top and bottom loading plates together.

During the UCS test, a constant displacement increment of 1 m/s is applied on the top loading plate in the vertical direction while the bottom loading plate is fixed in both vertical and horizontal directions.

This tester consists of an instrumented thin-walled circular cylinder, two platens, a commercial dynamic material test machine (MTS 810), a bottom load cell and twelve bi-axial strain gage rosettes.

Bottom: Load displacement for soft, brittle systems (e=7.63·10−6).

If your stove has a bottom, you can load it with fuel and then set it in its final position.

First 20 ml PBS/1,1 mM Ca2+/0.5 mM Mg2+/12 mM lactate was bottom-loaded in a chamber, followed by 50 ml cell suspension.

An early bottom-loading FED camera.