Sentence examples for both types of tubes from inspiring English sources
Particle cycle times follow an almost exponential distribution for both types of tubes and are highly dependent on the type of draft tube and contactor angle, especially in the range from 36° to 45°.
The level of bacterial colonization on the ETT surfaces was similar for both types of tubes, approximately 10 to 10 CFU/cm and overall low compared to other studies where the tracheal colonization has been investigated [ 25– 27].
Significant differences between the Mallinckrodt and Securisyn tubes, such as radius of curvature and surface features, prompted testing both types of tubes with traditional tape and twill methods as observed differences could provide insight into the effects of tube geometry on ET tube restraint performance.
As illustrated in Fig. 7, the 3-D model resulted in lower critical (cut-off) clearances for both types of tube materials (Ett = 0 GPa and Ett = 1.2 GPa) and higher contact stresses for strain hardening material than the axisymmetric model.
Both types of tube were incubated for 30 mins at room temperature to allow clot formation in the serum samples, and then centrifuged as described above.
Both aforementioned methods of fixation were tested using both types of ET tubes.
However, we observed tubular structures during sonication in both types of suspension, with more tubes aerosolized and captured on the filter when in water containing NOM.
These two types of tubes have identical crushing mechanism, including two crushing stages.
In addition to conventional FRP tubes, new types of tubes with integrated internal FRP reinforcement have been designed and tested.
The whole boiler including; walls, burners, air channels, three types of tubes, etc., was modeled in the real scale.
