Sentence examples for both reference signals from inspiring English sources

It is shown that simultaneous excitation of both reference signals does not improve the accuracy of the estimated controller parameters compared to the case with a single reference.

It is shown that simultaneous excitation of both reference signals does not improve the accuracy of the estimated controller parameters compared to the case of sequential excitation.

A type-II control loop achieves zero steady state position and velocity error, a type-III control loop achieves zero steady state position, velocity and acceleration error and therefore a type-p control loop is expected to track both faster reference signals and eliminate higher order errors at steady state.

The particular case of constant reference signals is referred to as the set point control problem.

The SPWVD of both the observed and reference signals (chosen as a cosinusoidal signal with the constant frequency of 0.1 Hz) is calculated with its time and lag smoothing windows [4] chosen as Hamming windows with durations of 15 s.

Although 60 nuclei were scored for each sample, only nuclei harboring both gene- and reference signals were included for further analysis.

The latter are referred to as common reference signals (CRSs) while the former are referred to as dedicated (or demodulation) reference signals (DRSs or DM-RSs).

It is important to note at this point that both the reference signal generation and the MoComp are done based on theoretical calculations of the appropriate range and phase histories.

Finally the reference signals are generated for both VCM and PZT actuators.

The proposed controller is robust for reference signals.

The reference signals in the 0 d q rotating frame are controlled to get the desired reference signals using PI controller.