Sentence examples for both methods at the from inspiring English sources

The Internet provider that sends an e-mail message can use both methods at the same time to vouch for the veracity of the sender's address.

The differences between benzene and groundwater flow rate estimates resulting from point scale samples and integral pumping tests were 6.44% and 6.97%, respectively, demonstrating the applicability of both methods at the site.

In order to compare both methods at the same - setting, for LS + APQ, we extract only features from the features, thus pairs from the LS pairing.

We calculated LRH for both methods at the furthest distance where the EHH was greater than either 0.25 or 0.05 at core haplotype.

MTR and LCA are also similar in that they output the same taxon for each read that is assigned by both methods at the same taxonomic rank.

There were 25 methods to be rated and both methods at the individual and at the environmental level were used (see Table  1).

For each dog, we determined the absolute bioavailability of BPA administered sublingually (both methods) at 5 mg/kg as the ratio of the normalized BPA AUClast for the sublingual route to the equivalent AUClast for the iv route.

Treatments with both methods at optimized conditions reduced the cytotoxicity and mutagenicity of PRW, however, UV/TiO2/H2O2 system was found slightly efficient as compared to gamma ray/H2O2.

In this retrospective study we evaluated both methods at 3 T and compared the diagnostic yield and rate of complications to determine the optimal biopsy technique at 3 T.

For the other four TF ChIP-seq libraries,(Essrb, E2F1, Tcfcp211, ZFX) out of 11 studied TFs specificity thresholds were defined by the both methods at a similar specificity cut-off (94%) (Table 1).

All examinations were re-analyzed by FKN using both methods at least three months after the first evaluations.The first step in both methods was to delineate the boundaries of the subregions manually by marking multiple points along the articular surfaces in each of the relevant slices to obtain an average reference SI value with SDs laterally and a BML volume estimate medially.