Sentence examples for bone height using the from inspiring English sources

Five doctors specializing in dental radiology from the Department of Oral Diagnosis at Tohoku University Graduate School of Dentistry independently measured rate of increase in alveolar bone height using the methods described in Figure 2. Errors caused by slight variation in angulations of X-ray imaging were corrected based on the distance between two immobile anatomical reference points.

This is a pre-clinical study of lengthening the alveolar bone height using a thin osteoperiosteal bone flap, the "island bone flap" or i-flap, to establish vitality, stability and incorporation of the augmentation material after healing.

If you don't have the slant height, use the pyramid's edge height.

If you have the slant height and perpendicular height, use the Pythagorean theorem (see "Tips" below).

Bone height was used as the outcome and each SNP as a potential predictor of bone height.

Realign bones using the closed reduction method.

Realign bones using the open reduction method.

Panoramic dental radiographs were provided from all subjects, using which the bone height of the lowest vertical height of the edentulous mandible was measured following the protocol of the American College of Prosthodontists (ACP) [27] (Figure 2A).

Gained bone height and width was quantified using the KaVo-eXam Vision software (Kavo Dental GmbH, Germany) and One Volume Viewer software (J. Morita Corporation, Japan) on one descriptive slide of the CBCT scan [21].

We determined that the higher the immediately postoperative bone height (iBH) was, the higher the subsequent total height would be.

The relative lesion height (RLH) was calculated using the formula: relative lesion height (RLH) = lesion height/plant height × 100.