Sentence examples for bone height of each from inspiring English sources

Change in crestal bone height of each implant was calculated from the differences between the initial and final measurements from standardized periapical radiographs.

We evaluated preoperative and the sequential postoperative radiological views to calculate the residual vertical bone height of each group.

Delayed implant placement was recommended for residual bone height of lower than 5 mm.

At T1, the root length and bone height of the two groups were comparable (Tables 2 and 3).

Overall, a total clinically relevant loss of bone height of approximately 2 5 mm in the first 6 months can be observed in the vertical dimension [10, 20].

A minimal native bone height of 4 mm (calculated from measurements on a preoperative panoramic radiograph) was preferred in both study groups.

It should be mentioned that in this study, a minimal native alveolar bone height of 4 mm was preferred, ensuring a certain primary stability of the dental implants placed.

The ACP classification was determined as: Type I: residual ridge bone height of 21 mm or greater; Type II: residual ridge bone height of 16 to 20 mm; Type III: residual ridge bone height of 11 to 15 mm; and Type IV: residual ridge bone height of 10 mm or less [27].

The ACP classification determines: Type I: residual ridge bone height of 21 mm or greater; Type II: residual ridge bone height of 16 to 20 mm; Type III: residual ridge bone height of 11 to 15 mm; and Type IV: residual ridge bone height of 10 mm or less.

Panoramic dental radiographs were provided from all subjects, using which the bone height of the lowest vertical height of the edentulous mandible was measured following the protocol of the American College of Prosthodontists (ACP) [27] (Figure 2A).

The average bone height of the subjects with rs840869 or rs859024 minor alleles (10.6±3.2 mm and 9.6±3.2 mm, respectively) was significantly smaller than that of those subjects with the major alleles (14.2±4.5 mm, p<0.05).