3 Ignition of the reactive bonding layer by a laser pulse through the top substrate while applying pressure.
The finite-element and fracture analysis of these joints indicated that the failure of mullite and SiC joints only occurred at bonding layer, while that of C/C joints occurred at both bonding layer and interface.
However, the bonding layer existing between the interconnect and the ceramic cell increases mass transfer resistance, resulting in decreased performance.
Next, a Cr (300 Å)/Pt (500 Å)/Au (15,000 Å) bonding layer was evaporated to cover the gap and the entire area.
In this paper, the valence electron densities ρh k l and ρuvw of the two sides and their difference Δρmin of the bonding layer/ceramic layer interface of thermal barrier coatings are calculated with the empirical electron theory in solids and molecules at various bonding layer yttrium content.
Crack-free joining of alumina and silicon nitride has been achieved by a unique approach introducing sialon polytypoids as a functionally graded materials (FGM) bonding layer.
Because the epoxy resin acted as bonding layer between the R974 nanoparticles film and the glass slide, a combination of high bonding strength and superhydrophobicity was achieved.
Thus, the thickness of the silver epoxy bonding layer was used as a design parameter to optimize the structure for the transducer input impedance to match the 50 Ω output impedance of most radio frequency (RF) generators.
The microstructure evolution, including crack and pore formation, was analyzed, besides the behavior of bonding layer between tungsten and SiC/SiC was evaluated by C-scanning images of ultrasonic method and Electron probe Micro-analyzer (EPMA).
The ultimate failure of the biomimetic integrated honeycomb without a bonding layer between the panel core layers is determined by the material strength itself; therefore, the honeycomb possesses good mechanical properties.
A coating to resist fretting fatigue consisting of a nickel bottom bonding layer and a ferrite and austenite dual-phase top layer was prepared by thermally spraying the axles.
