Sentence examples for bonded length from inspiring English sources

In the case of a specimen using NSMR, as de-bonded length is shorter (bonded length is longer), strength increase by retrofit is larger.

The average ultimate bond stress over the entire bonded length was a function of anchor diameters and bonded length.

It was found that pull-out load increased approximately linearly with the bonded length up to maximum which occurred at a bonded length of 250 mm (∼15 times the hole diameter) and did not increase beyond this bonded length.

Similarly, for the same bonded area, the bond stress at failure tended to decrease by increasing the bonded length.

Among the investigated variables were: type of FRP rod (material and surface pattern), groove-filling material, bonded length, and groove size.

At 250 mm bonded length, the pull-out capacity of the proposed design model was about 2% lower than that of the tests.

This has special importance in those cases where the bonded length is short and the effective bond length of the interface is not ensured.

Also, the strength of the interface increases with the increase of the bonded length which have consequences on the definition of the effective bond length.

Although CP500-3 specimen had a de-bonded length of 600 mm, it showed the same strength as CP1600-3 specimen with fully bonded FRP for whole length.

In the case of NSMR using a line, CP1600-1 specimen without de-bonding showed the strain values which is very similar to CP300-1 whose de-bonded length in a central part is 1000 mm.

A new test method named the "de-bonded length" test was designed, developed and validated.