Sentence examples for bits to be decoded from inspiring English sources

The iterative decoding methods described above use soft information about the bits to be decoded in the form of log-likelihood ratios (LLRs).

The above expression indicates that if the probability of successful decoding for a single bit is used as a criterion, the performance of ML bit decoding in phase-locked mode is insensitive to the number of bits to be decoded at a time.

However, assuming that the performance of ML bit decoding in frequency locked mode is insensitive to the number of bits to be decoded at a time (later we will confirm with a multiple-trial test), an approximate form can be given based on (21) as P d, FL ≈ 1 - P e, diff N 2 (22).

Consider the case of two bits to be decoded at a time.

Two bits to be decoded at a time are considered in phase-locked mode and frequency-locked mode.

The bit sequence with more bits to be decoded at a time has lower ability to tolerate Doppler error.

The packets of bits need to be decoded and pieced together to make each image.

In order to avoid this, it is necessary to allow for wide margins, and this can be done by increasing the available amplitude range through power amplification of the RF signal at the transmitter (to effectively spread the symbols out more); otherwise, data bits may be decoded incorrectly at the receiver, resulting in increased bit error rate (BER) [1, 8].

When enough number of linearly uncorrelated equations are obtained, the bits can be decoded.

As shown in Fig. 2, if all the signal levels are occupied, only three bits can be decoded for the two users.

Based on the requested parity bits transmitted from the encoder and the received BMM, each bit plane can be decoded with reference to the side information and the CNM characterizing the statistical dependency between WZBs and corresponding SIBs.