Sentence examples for binary parameters for the from inspiring English sources
The binary parameters for the other pairs are taken directly from the literature.
This strategy is based on the analysis of the distillation column phase equilibrium sensitivity and leads to an unique matrix of equation of state dominant binary parameters for the whole fractionation train.
The binary parameters for the classical van der Waals quadratic mixing rule (vdW2) were systematically estimated, together with a new set of Clausius Clapeyron solute vapor pressure in order to describe the temperature dependence and achieve experimental solubility uncertainties.
There were two parameters for field soil moisture, at 30 and 15 cm below ground (measured with tensiometers in the rainfed field and estimated to be constant at soil saturation value in the irrigated field), and a binary parameter for the field (irrigated or rainfed).
If the binary parameters for a ternary solution are not accessible, a model based upon the binary parameters of binary solutions may provide a very acceptable means of predicting the flash points for the ternary solution as revealed by a comparison between predicted and experimental data.
These binary parameters are then integrated with published binary parameters for other subsystems present in the quaternary system.
Only the binary parameters for polymer solvent and polymer/non-solvent pairs were adjusted to obtain a useful representation of experimental LLE data for the ternary systems.
The thermodynamic model of decanters was different because in these units the binary parameters for liquid liquid equilibrium were used.
Additionally, binary parameters for glycerol/methanol, methanol/methyl oleate and glycerol/methyl oleate have been estimated by NRTL and UNIQUAC models.
The calculated ternary compositions were found to be in good agreement with the experimental data using the binary parameters from the data of binary pairs for both EOSs.
Straightforward extension to mixtures requires one characteristic binary parameter for "physical" interactions and, for polar-polar mixtures, another for "chemical" interactions.
