Sentence examples for between these two traces from inspiring English sources

Choice results from the interaction between these two traces so that if the subjective intensity of one of the reinforcers, the appetitive or the aversive, overcomes that of the alternative reinforcer, choice would be biased towards the dominant CS.

In any differential conditioning two specific memory traces are established, an excitatory one derived from CS+ experiences, and an inhibitory one derived from CS− experiences; choice following conditioning with a CS+ and a CS− results from the interaction between these two traces [16].

Hence, the agreement of both position and shape between the two traces is the first and only direct evidence to date for minimally invasive IC recording by a nanodevice.

The agreement between the two traces was remarkable, which was expected if the signal is an IG wave whose phase velocity is much lower than that of a seismic wave (Crawford et al. 1991).

The small deviation between the two traces toward the end of each simulation is due to the incomplete settlement of the model output just before the second step in panel A, which causes HB to increasingly (but only slightly) underestimate the force induced by the second step.

In the first, the differences between the two traces are attributable to sequencing error only, and must be consistent with the reported position-specific quality scores.

However, noticeable discrepancies in the modeled and experimentally derived trends are also visible in Figure 5, especially between T150 and T210 and after T265 where the gradient between the two traces are of opposite slope.

The differences between the four traces on the oscilloscope display, each indicating the average compression in the direction of the detector, allowed the assessment of the required synchronization accuracy for the detonators.

In between these two fears, Brunner traces how people were so fascinated by their glimpses of what the ocean contained — thanks to diving bells and what was dredged up as transatlantic cables were being laid — that they wanted to capture its essence in miniature.

Further, the crosstalk analysis for a 60 mV swing around VT at 180 nm CMOS process and single ended point to point drivers portrays that the desired s/h (s is the edge to edge space between two traces and h is the corresponding height from the ground plane) has to be greater than 2.3 for crosstalk noise to be below the critical value.

This approach is based on event matching between two traces.