Sentence examples for between the two orientations from inspiring English sources

Whereas straight guys had been intrigued with gay life before and could (almost) contemplate experimenting, suddenly the barrier between the two orientations shot up, higher than the Iron Curtain.

For rooftops oriented towards east/west, an interesting possibility could be to split the total installed capacity (equally) between the two orientations.

The difference in crack growth resistance between the two orientations decreases with increasing temperature and is basically non-existent at 300 °C.

Strain transfer between the two orientations leads to complex stress/strain states, hindering interpretations of plastic deformation behaviors such as strain hardening and anelasticity.

While a negligible life difference was observed in the equiax grained material between the two orientations, a consistently lower accumulated inelastic strain was measured for the material loaded parallel to the build direction than the transverse orientation.

There have been several attempts to explicitly forge connections between the two orientations (Foster 1998, Moore 1999 2008, Berleant and Carlson 2007).

Computation shows that increasing the length of the microtubules while keeping their number the same as previously considered (N = 88) only blurs the distinction between the two orientation modes without shifting their relative weight (Fig. 3B D).

Student-Newman-Keuls tests (with P = 0.05) were used to test for differences between each of the ten combinations of the orientation and stolon length treatments and between the five orientation treatments across stolon length treatments.

The difference in the dissolution rate between these two orientations can be understood largely in terms of a difference in the electronic and morphological properties of SRO films, as discussed below.

The graphical pathway representation in Figure 2 is incapable of showing the difference between these two orientations.

Cyclic voltammetry and simultaneous capacity measurements were performed on the two crystal faces of an iron (1 0 0)/(1 1 1) bi-crystal, on the grain boundary between these two orientations and on several single grains of a coarse grain iron sample.