Sentence examples for between the top surface from inspiring English sources

The mixture of gas and fluid introduces a surface impedance discontinuity between the top surface of the panel and the top surface of the layer, the top surface being in contact with the semi-infinite fluid above the panel.

With the high heat flux of 0.68 MW m−2, the thickest specimen exhibits a high surface temperature of 1690 °C and the corresponding temperature difference between the top surface and the bottom surface of the coating is high up to 760 °C.

Figure 5 shows that there is a temperature difference between the top surface of the slab and the air.

This peak comes from interference between the top surface of the chitosan (the air/chitosan interface) and the bottom of the porous Si film (the bulk Si/porous Si interface).

This slope is guided from the loaded area edge to a distance of 2d (blue dotted line), where d is the distance between the top surface and reinforcement (blue dotted line).

e The CL spectrum obtained in spot mode from the center of the MR. f The CL spectrum obtained in spot mode from the edge of the MR. In fact, the inhomogeneous distribution of the acceptor-like defects occurs not only between the center and edge of the MRs but also between the top surface and the bulk underneath the surface.

Heat loss through the ice takes place by conduction; designated ϕ in the figure, it is proportional to the thermal conductivity of the ice (ki) and to the temperature difference between the bottom and the top surface of the ice (Tm - Ts), and it is inversely proportional to the thickness of the ice (h).

Analyzing the stress exponent and the activation volume suggests that the enhanced plasticity may be controlled by the diffusion creep (through the "space-charge layer" near the surface and/or along the interface between the punch and the top surface of the rod), which is supported by the results from in situ creep tests under electron-beam irradiation and in situ electric measurements.

It can be ascribed to the Fabry-Perot resonances between the substrate and the top surface of SiNWAs.

Adhesion between the film adhesive and the top surface of a silicon chip was successfully measured.

The anisotropy in the mechanical properties between the cross section and the top surface of the ceramic coatings is examined.