Sentence examples for between the reflection coefficient from inspiring English sources

The relationship between the reflection coefficient measurements and the MC is studied.

Figure 2 shows the relationship between the reflection coefficient of the mud casing interface and the frequency of the incident wave.

To verify the simulation correctness, according to Eqs. (8) and (10), the relationship between the reflection coefficient obtained from fitting and that obtained from calculation can be estimated.

In particular, the model predicts two types of behavior depending on the ratio between the reflection coefficient and the so-called chemomechanical coupling coefficient that quantifies the volumetric strain as a result of a change in ion content.

By observing the relationship between the reflection coefficient obtained from the irreversible thermodynamic model and that obtained from the steric-hindrance pore model, the simulation correctness can be verified.

By minimizing the error between the reflection coefficients from measurements and those from the prediction model, in the frequency bands in which the guided waves are sensitive to the discontinuity and can propagate with low decay rate, the discontinuity position parameter in the prediction model can then be identified.

Central arteries should be less sensitive to variations in response to vasoactive drugs as the arteriolar tone is already high, and the reflection coefficient (the ratio between the reflected wave and the incident wave in the frequency domain) can be increased only marginally by intense vasoconstriction [ 13].

In the ultrasound study, which comprised theoretical modelling and experimental testing, discrimination of differing steel and concrete substructure thicknesses and also of gaps between them was possible using the reflection coefficient.

The computational time interval Δt is 1.0 × 10−3 s, The maximum permissible error of the continuity equation Dmax is 1.0 × 10−5, fluid density ρ is 1.0 × 103 kinematicnematic viscosity ν is 1.0 × 10−6 m2/s, density of the driftage ρ d is 0.5 × 103 kg/m3, and the reflection coefficient between the driftage and vertical wall e is 0.5.

Concentration increases within the experimental apparatus at the end of the experiments ranged between 1.25 and 1.55 for nitrate and 1.43 and 1.49 for phosphate times greater than the initial concentration and the calculated values of the reflection coefficient ranged between 0.58 to 0.84 for nitrate and from 0.76 to 0.88 for phosphate.

We determined the reflection coefficient, α, and delay, ΔT, between direct and reflected signal.