where β coupl μ,k) is referred to as the coupling between the reference spectrum and the error spectrum.
The image comparison is obtained by applying Spectral Angle Mapper between the reference spectrum and each multitemporal image.
For the identification of the analytes, the correlation between the PARAFAC spectral loadings and the reference spectra has been used.
The reference spectra at day zero were within and in between the other spectra showing there was no change in omeprazole Mg alone and with the excipients when subjected to different conditions for a period of 90 days.
The spectra obtained from the unmixed ROI shown in Figure 8 were comparable to the reference spectra.
On the other hand, CMN is not applied when computing LLR and SNR, so applying CMN on the target log-magnitude spectrum during DNN training effectively causes a mismatch between the enhanced spectrum and the reference spectrum.
In the frequency ranges in which the spectral ratios are larger than the noise level, defined by the spectral ratio between the noise spectrum and the reference spectrum, the logarithms of spectral ratios exhibit almost constant decay slopes, meaning that the Δt* is relatively constant, independent of frequency.
The mean square error between the experimental data fitting and the reference spectrum fitting was determined in each case, and was used as the dependant variable for the experimental design analysis.
Figure 5 b shows differential spectra during sweeping the potential between 0 mV and 1300 mV with the reference spectrum at 0 mV.
The reference spectrum (day 0 spectrum) was found in between other spectra in the near infrared region.
