Sentence examples for between the particle bed from inspiring English sources

Two modes of contact between the particle bed and the vessel base are clearly defined and the mathematical implication of dealing with the contact is described.

It is found that heat exchanger effectiveness is maximized for higher entry temperatures and for optimum values of the geometry and residence time balancing enhanced heat transfer between the particle beds and increased losses to the environment.

A very high gas injection velocity prevents efficient penetration of especially fine/light particles in the gas inlet jets which is detrimental for the transfer of tangential momentum between the gas and the particle bed.

a shows a top view of the particle bed, where lift forces are measured at the red-colored centerline particles.

Heat transfer in the particle beds and between the beds and the separating wall is described with published models, and the results are compared with experimental data from the literature.

This paper is concerned with a quantitive treatment of the impulse of the collision between vibrating particle beds and a vessle base.

Heat transfer between the riser wall and particle bed in a circulating fluidized bed (CFB) of fluid catalytic cracking (FCC) particles has been studied in terms of the local bed densities and solid particle velocities near the heat transfer surface, which were measured by reflection-type optical-fiber probes.

The pyrolysis was tested by varying the temperature of solid heat carrier, thickness of particle bed between the side and central channels, and ash-to-shale mass blending ratio in terms of the oil and gas product distribution and qualities.

Axial profile of dispersion coefficient predicted by the various correlations exhibited a sharp variation in the intermixing zone formed in between the lower (higher density) and upper particle bed (low density).

The contact area change was calculated by assuming a simple geometrical deformation caused the difference between the particle expansion and the packed bed expansion.

In the Wurster process, a coating solution is sprayed on a particle bed moved by an ascending gas stream.