Sentence examples for between the electrodes using from inspiring English sources
Voltage was applied between the electrodes using a pulsed DC power supply.
EIS was carred out in the dark condition to investigate the discrepancy of the interfacial recombination between the electrodes using TN0 and TN2. Figure 5 presents the typical Nyquist plots of the TN0- and TN2-based cells.
NTIRE was performed by applying short electric pulses between the electrodes using a high voltage pulse generator intended for electroporation procedures (ECM 830, Harvard Apparatus, Holliston, MA).
A sequence of 10 direct current square pulses of 380 V (generating an approximate electrical field of 3800 V/cm), each 100 µs long, was applied between the electrodes using an electroporation pulse generator ECM2001 (BTX, Cambridge MA) [9].
Five unidirectional squared electrical pulses (25 30 V, 50 ms each at 1-s intervals) were delivered through platinum electrodes (2 mm diameter, ≈5 mm distance between the electrodes), using a BTX®-ECM®830 electroporator.
A sequence of 50 DC pulses of 200 V (corresponding to an electric field of ∼2000 V cm−1), 70 μs each, and a frequency of 4 Hz was applied between the electrodes using a high voltage pulse generator designed for electroporation procedures (ECM 80, Harvard Apparatus).
Immediately after injection, within 20 s, electrical pulses were delivered to the fish by holding it between the tweezer electrodes using electric pulse generator (Electro Square porator ECM 830, BTX, San Diego, CA).
The impedance between the skin electrodes used for reference and ground, measured on the subject, should be less than 5 kΩ.
Plasma was generated by applying alternating polarity pulsed (500 Hz –1.5 kHz) voltage of 20 kV magnitude (peak to peak), 1.65 µs pulse width and a rise time of 5 V/ns between the high voltage electrodes using a variable voltage and variable frequency power supply (Quinta, Russia).
The fabrication technique also allowed measurements of electrical conductivity of a single suspended CNF between carbon electrodes using I V characteristics and comparison of the carbon nanowire conductivities for the CNF derived from different polymer precursors.
The electrical stimulus could be switched between electrodes using a remote controlled electric relay, interposed between the isolation unit and the stimulation electrodes.
