Sentence examples for between the diffusion layer from inspiring English sources

The relationship between the diffusion layer, reaction layer, the electrode dimension and the kinetic rate constant at an ultramicroelectrode is discussed and the factor effect on the reaction order is described.

In this paper, a discussion is made of the dependence between the diffusion layer thickness and the potential sweep rate and the potential value for reversible charge transfer processes studied under the application of a linear potential sweep.

We found that the behavior of the system depends crucially on the relation between the diffusion layer thickness, zd, and the kinetic layer thickness, zk (determined by the rate of the homogeneous reaction).

Applying this method for treatment of impedance experimental data leads to the conclusion that the difference between the diffusion layer thicknesses found from the experiment in the conditions of an imposed steady state DC and theoretically by applying the Lévêque equation is higher than it was believed when assuming D = const.

The simulations performed with the model indicate that an optimal physical design of the fuel cell's flow channel land area or current collector exists when considering the pressure differential between channels, and the diffusion layer permeability and conductivity.

A larger flow channel area ratio increases the contact area between the fuel and the diffusion layer, which allows more fuel to directly diffuse into the porous layers to participate in the electrochemical reaction which enhances the reaction rates.

A thin layer of fast degrading 50/50PLGA was placed as the diffusion layer between the 85/15PLGA layers to prevent any burst-type release.

After adding a small amount of Mo to Ti, the growth rate of the diffusion layer between Ti and Yb0.3Co4Sb12 decreased.

Oxidation of TCNQ− in the PEO networks occurs via both of physical diffusion of TCNQ− toward the electrode and the electron self exchange between TCNQ− and TCNQ0 in the diffusion layer.

In order to equalize the diffusion rate of chemical species and chemical reaction rate for the transport of carbonate ions from the source to the receiving phase, the stirring of bulk source and receiving phases are essential to minimize the diffusion layer in between the interfaces for the chemical species in bulk solution and also solution in the fibers.

This mainly follows from the increase in the repulsion forces between strongly ionized polymer chains in the diffusion layer of the solid particles.