Sentence examples for between the case without from inspiring English sources
Measurement results of instantaneous 2D pressure distributions at 1.2 kHz for normal incidence presented in Fig. 7b demonstrate a perfect transmission in which both amplitude and phase of the intensity distribution are nearly identical between the case without presence of wall and the case with presence of membranes of the structure.
The experimental results show that, for increasing the air flow rate from 250 to 1450 m3/h, the temperature difference of hot water through the evaporative condenser change in the ranges between 13 and 24.9 °C for the case without pre-cooling unit, 17.6 38.4 °C for using the pre-cooling unit with internal baffles and with use the thin film cotton layer.
This is evidenced by comparing figures 5(a - b) with figures 6(a - b) in withh there is little or no difigurese between the case with EPO and the case without.
From the calculated hole Landau levels we determine the density of states at the Fermi energy and demonstrate a clear difference between the symmetric case without bias and the asymmetric case with a gate voltage of 100 meV, where the spin subband populations differ by a factor 3.
The difference in CO2 emissions between the baseline case, without PHEVs charging and with PHEVs charging for both the peak and off-peak scenarios is 598 kilotonne of CO2 (ktCO2) and 375 ktCO2, respectively in 2020.
The difference in CO2 emissions between the baseline case, without PHEVs charging and with PHEVs charging for both the peak and off-peak scenarios is 598 ktCO2 and 375 ktCO2, respectively in 2020.
Control periods were chosen 4 weeks before or after the index event to effectively control for temporal trends but without overlap between the case and control exposure periods.
Comparisons are made between the cases with and without the binary tree and spline interpolation added to a standard GA.
The comparison between the cases with and without current load revealed metal melting as a result of current heating.
On the basis of adapting the generalized FE model of the rail joint to simulating the CE process, a comparison between the cases with and without CE of rail-end-bolt holes has been made.
Comparison between the cases with and without validation also reveals the importance of I/ Qimbalance validation.
