Sentence examples for between samples annealed at from inspiring English sources
The nano-hardness increased almost linearly with increasing Cu content owing to this grain refinement, though differences between samples annealed at different temperatures were found which could be related to the evolution of Ti(Ni, Cu 2 plate precipitates with annealing temperature and Cu content.
We also performed PDS, which is a very sensitive optical absorption technique, to compare the density of states between samples annealed at different temperatures.
In order to compare the oxygen vacancy concentration at different temperatures, we performed compositional analysis between samples annealed at 300, 350, and 400 °C (Table S1, Supporting Information).
It is worth noting that the low-temperature TRPL measurements presented in this work were performed at a relatively low excitation power density (3 W/cm2) to minimize the saturation of the localized states[21], which can obscure the differences between the samples annealed at different temperatures.
The intensity difference between ZnO-nc SiO2 ZnO-nc SiO212:(ZnO-nc:SiO2) sandlEu3+nnealed at 450 °C which is due to the incorporation of Eu3+ ions Fig. 7 A comparison of the spectral overlap integral and ZnO-nc SiO2sion ZnO-nc SiO2ifference integral.
This intensity difference is due to the energy loss from the various ZnO-nc emission centres because of the incorporation of the Eu3+ ions. Figure 6 shows the intensity differences of each of the seven ZnO-nc emission centres between ZnO-nc SiO2 ZnO-nc SiO212:(ZnO-nc:SiO2) sandlEu3+nnealed at 450 °C.
To determine if the obvious change of interfacial morphology correlates with a potential increase in crystallinity, GIXD measurements were performed on samples annealed at 100 °C for different periods between 2 and 250 min (compare the Supporting Information).
From these results we supposed that the samples annealed at lower temperature contained many nanopores between SPS chains of mesophase, i.e. desorption sites of solvent.
(d) Correlation function curves of the samples annealed at 553 K for different durations.
TEM images: different lamellas from samples annealed at selected current densities.
(c) Annealing time ta dependence of the normalized remaining enthalpy for the samples annealed at 473, 503, 523 and 553 K and their corresponding fittings by KWW function.
