All these orientation maps look similar, even in distantly related species [5, 9]; the main difference between any two orientation preference maps (OPM) seems to be a matter of global scaling.
The results were compared between cubic and honeycomb unit designs, between two orientations and across five different densities.
There have been several attempts to explicitly forge connections between the two orientations (Foster 1998, Moore 1999 2008, Berleant and Carlson 2007).
The spin of the Ising model can point up (spin value +1) or point down (spin value -1), and it flips between the two orientations.
For rooftops oriented towards east/west, an interesting possibility could be to split the total installed capacity (equally) between the two orientations.
The difference in crack growth resistance between the two orientations decreases with increasing temperature and is basically non-existent at 300 °C.
Strain transfer between the two orientations leads to complex stress/strain states, hindering interpretations of plastic deformation behaviors such as strain hardening and anelasticity.
While a negligible life difference was observed in the equiax grained material between the two orientations, a consistently lower accumulated inelastic strain was measured for the material loaded parallel to the build direction than the transverse orientation.
Cyclic voltammetry and simultaneous capacity measurements were performed on the two crystal faces of an iron (1 0 0)/(1 1 1) bi-crystal, on the grain boundary between these two orientations and on several single grains of a coarse grain iron sample.
Specifically, to compare the accuracy of the orientation measure computed by the particular algorithm considered on brushstroke i with respect to the corresponding observation by the human subject j, the angular distance D α (i,j) has been defined as the smallest angle between the two orientations.
