Sentence examples for better interfacial adhesion between from inspiring English sources

This feature clearly indicates better interfacial adhesion between the amino functionalized MWCNTs and matrix as compared to acid functionalized MWCNTs.

This may indicate a better interfacial adhesion between silane-treated BNNPs and epoxy matrix.Figure 6 presents thermal conductivity values and thermal conductivity improvements (thermal conductivity ratio between composite and pristine epoxy) of as-fabricated composites.

In conclusion, it was found that the addition of the nano-organoclay allows improving the proprieties of silane grafted clays nanocomposites, which can endorse better interfacial adhesion between the organoclay and the polypropylene and their great spatial dispersion-distribution.

Here it has been established that the embedding of PPy-GO hybrids into pristine epoxy endows optimum dispersion of PPy and GO as well as better interfacial adhesion between the fillers and matrix, which results in a significant improvement in load transfer effectiveness.

It is found that BMI composite with APDBD treated MWCNTs exhibits a lower friction coefficient value and a lower wear loss rate value than the composite with original MWCNTs, which can be related to the higher degree of crosslink of the resin and also better interfacial adhesion between MWCNTs and the BMI matrix.

Adding a small amount (5 phr) of POB-PET to the originally immiscible blends of liquid crystalline copoly(oxybenzoate-naphthalate) (73/27), Vectra, and PEI resulted in better interfacial adhesions between Vectra and PEI as evidenced by the morphological observations with scanning electron microscopy.

This is due to better tensile properties of the PLA film and better interfacial adhesion in PLA-SRC.

Blends including the graft copolymer present a better interfacial adhesion and a reduction of the size of the dispersed phase in comparison with blends without additive.

The tensile and impact properties of the UPE composites showed that VPS-lignin/UPE composites performed better than the pristine lignin/UPE composites due to improved interfacial adhesion between the lignin filler and UPE matrix.

This improvement in specific interlaminar shear strength was postulated to be due to the lowering of the resin viscosity over the duration of the cure, resulting in better wet through of fibres by resin and improved interfacial adhesion between fibre and matrix.

Scanning electron microscopy (SEM) analysis showed that MA pretreatment significantly improved the dispersion of SCB in the composites and interfacial adhesion between SCB and PVC matrix, resulting in better mechanical properties of the composites.