Sentence examples for bent indicating that from inspiring English sources

Tornetta et al. described the concept of different modes of failure [30], reporting that standard screws cut through the sacrum while long screws bent, indicating that the long screw was better anchored at its distal end [30].

High inter-observer reliability was found in flexion, extension, axial rotation and lateral bending indicating that the testing routine is applicable for different examiners.

The results obtained, including design formulae for the time-dependent creep coefficients for shear and bending, indicate that the creepocity due to shear is much higher, with reductions after 50-years in the effective flexural and shear stiffness of 22% and 43%, respectively.

§A negative value for head lateral bend indicated that the head was bent in the frontal plane to the left.

A similar behavior was observed for the samples submitted to bending loads, indicating that bending test was also efficient to indicate the composite degradation under thermal loads.

These quasi-flat dispersion curves, supporting the propagation of waves with extremely slow group velocity, tend to be perfect zero-frequency modes for zero torsional rigidity or vanish for zero bending rigidity, indicating that weak bending and torsional interbead interactions are critical in the transformation of zero-frequency modes into extremely slow propagating modes.

The latter band may be due to PO-H bending vibration indicating that the complex formed is protonated.

In many specimens the distal portions of spines bend sharply, indicating that the sail would have had an irregular profile in life.

Results indicate that peak forward bending moments as well as spinal compression and shear forces are higher when the pallet is situated at the side of the conveyor as opposed to the end of the conveyor.

The bending test indicates that the obtained supercapacitor is flexible and its performance is only decreased 10% after 800 bending cycles with a bending angle of 180.

Also, there are peaks at around 1,500 cm−1 which may be attributed to NH2 bending mode [35] indicating that the final graphene product contains a small amount of oleylamine after washing.