Sentence examples for bending tests were used from inspiring English sources

Compressive strength and four point bending tests were used for mechanical characteristics of ECC mixtures at 28 days.

Four-point bending tests were used to precrack ECC beams at different age, followed by different curing conditions, including air curing, 3% CO2 concentration curing, cyclic wet/dry (dry under 3% CO2 concentration) curing and water curing.

The results of the stub column and simple bending tests were used to assess the current slenderness limits given in Eurocode 3, including the possible dependency on production route, whilst the results of the continuous beam tests were evaluated with reference to the assumptions typically made in plastic analysis and design.

The Double Cantilever Beam, End-Notched Flexure and Single-Leg Bending tests were used for fatigue/fracture characterization under high-cycle fatigue loading.

The experimental results of bending tests are used to validate the proposed design equation.

Rapid penetration test and four point bending test were used to assess the influence of self-healing on water permeability and mechanical properties of MES-ECC.

Charpy impact test and three-point bending test were used in order to obtained the impact response and flexural behavior of different laminates.

A four-point bending test was used in the experimental test.

The mixed-mode bending test is used owing to its aptitude for easier alteration of mode ratio.

Under mixed-mode I + II loading the mixed-mode bending test was used considering different mixed-mode ratios.

Bending test was used to measure the modulus of rupture, material's energy absorbency and analyse the fatigue response of RCC mixes.