Sentence examples for bending situation from inspiring English sources

Finally, the flexible N-doped GF-based EDLC is also tested as a wearable supercapacitor, exhibiting no capacitance decrease under the dynamic bending situation.

Thus, the risk of catastrophic failure is higher in the case of tensile loading (in relation to the less dangerous bending situation) if a local fracture criterion (on the basis of the maximum local SIF K along the crack front) is used, considering that fracture takes place when K reaches the material fracture toughness KC.

Stable performance at bending situation is a critical challenge.

From I-V results, the dark current decreased, and the UV-to-visible rejection ratio increased slightly in bending situation.

From I-V curve, it was found that the dark current decreased slightly and the UV-to-visible rejection ratio increased slightly in bending situation.

Therefore, a bending situation is more evident at the outer region of the concave center in the impurity-induced hemisphere curve.

However, because small variations in switching properties for the polarization reversal were also observed especially for higher frequency and lower voltage regions, suitable operation schemes should be designed for the flexible memory devices with lower voltage and higher speed operations even at bending situations.

We show how the microscopic features of the carapace govern its various macroscopic mechanical responses relevant to protective functioning, including dynamic (impact and cyclic) compression and bending loading situations.

The main difficulty is to reduce the locking phenomenon arising in bending dominated situations without destroying the ability of the procedure to accurately capture membrane dominated and mixed behaviors.

I wanted to be tough, hardnosed, to bend this situation to my will by not giving in to the emotions flaring inside me, my heart beating against my chest like a fly against the window glass on a sunny day.

In bending (a common manufacturing situation), geometric conformance is maximised when forming time is 60 s, forming rate is 250 mm/min and forming radius/thickness ratio is 2 for the composite sheets studied in this paper.