Sentence examples for bending process of a from inspiring English sources

We further investigated the bending process of a 23-layer MoS2 flake (Fig. 4 and Supplementary Movie 8).

Springback simulations of a two-dimensional draw bending process of a high strength steel sheet are then carried out using the polyhedral and Nagata patch models.

During the bending process of switch components a high strain is applied to the outer fiber of the rail foot, about ten times larger than in normal operation when a train passes through the rail.

The outline of this study is as follows: the 'Methods' section discusses the AFM characterization of atomic-scale wear and nanometer-scale mechanical processing of muscovite; the 'Results and discussion' section concentrates on the mechanical nanoprocessing of layered crystalline structures by AFM and the bending process of graphene; and the 'Conclusions' section concludes with an outlook.

Furthermore, the Taguchi experimental design method was employed to pin point parameters, which significantly affect the bending process of laser bending of St12 and 304 alloy steels, which have a wide range of applications in products manufacturing.

This paper presents a comprehensive experimental and numerical study of laser bending process of thin-walled micro-tubes.

The bending process of hybrid intelligent hinge system is simulated and divided into three typical stages which correspond to three different bending mechanisms.

We show that there exist low- and high-strain phases during the bending process of CNTs, and the transition in between may divide the whole bending process into three stages: low-curvature stage, mixed-curvature stage and high-curvature stage.

It is consistent with the hypothesis that intraslab earthquakes are thought to be a reactivation of the pre-existing hydrated weak zones produced in the bending process of oceanic plates around outer-rise regions.

This can be interpreted by the hypothesis that intraslab earthquakes are caused by a reactivation of the pre-existing hydrated weak zones produced in the bending process of oceanic plates at the outer-rise zone.

The ANN model is integrated with the FEM model to incorporate predicted absorptivity for accurate simulation of laser bending process for a wide range of process conditions.