Sentence examples for bending mode of a from inspiring English sources
A peak at 798 couldcould be assigned to the bending mode of a secondary amine (−NH).
Free vibration analysis shows that the fundamental natural frequency of the gate structure is 1799 Hz whose corresponding mode shape is a typical bending mode of a plate.
In this article, the Continuous Wavelet Transform (CWT) is used to study the amplitude dependency of the natural frequency and the equivalent viscous modal damping ratio of the first vertical bending mode of a ballasted, single span, concrete steel composite railway bridge.
Many swimming C. elegans produce a bending wave with two distinct nodes (Fig. 1b), a shape similar to the first bending mode of a simple elastic rod.
We use two orthogonal 1st bending modes of a symmetrical beam to produce elliptical movements on two driving feet; therefore, the design and fabrication process of the proposed piezoelectric actuator is quite easy.
The modes are divided into two separate groups; type 1 modes are similar to the bending modes of a flat plate, while type 2 modes involve out-of-plane motion but in-plane elastic tractions.
Here, we derive an analytical model of squeeze air film damping of first two fundamental vibration modes, namely, rocking and bending modes, of a directional microphone inspired from the fly Ormia ochracea׳s ear anatomy.
A damping patch is shown to behave as a constrained layer damper (CLD) for the bending modes of a tapered cantilevered plate, while behaving as a tuned damper for the sway modes.
In addition, the carbody vibration resonances locate at the first and third bending modes of carbody, because the center gets the maximum displacements and acceleration for the first- and third-order bending modes of an elastic beam.
Previous experimental work has identified variations in the natural frequency and the modal damping ratio of the first vertical bending mode of vibration of a simply supported, single span steel concrete composite bridge.
For the given chamber geometry, the bending mode of measurement exhibits a lower thermal lag than the tensile one.
