More investigations are needed to further generalize TELM; some of these have been listed below: In finding the design point it is required to find the response and its sensitivity with direct differentiation method, this is the most challenging part of TELM, thus developing the sensitivity analysis for using the other material models is necessary.
The maximum temperatures of the coil at the base and maximum speeds, which were set as the design points, were below the motor temperature limit, being 138.1 and 137.8 °C, respectively.
Unlike coal power plants, however, CST plants frequently experience thermal loads well above and below their rated design point, leading to off-design operation for much of the operational year.
Below the design, all in capital letters, was "Licata".
Gunter, however, pointed to an NRC event notification from June 17 at Fort Calhoun, which suggested that the facility was still struggling to plug leaks even with water levels below the designed flood limit of 1,014 feet.
Therefore, the fatigue design of components submitted to loadings below the knee point of the SN-curve must consider this fact in order to avoid failures.
The compacts with three layers were hot-pressed at temperature below the melting point of Cu to keep the adjusted graded design.
Finally, an alternative PCM system geometry based on concentric pipes is designed to keep the maximum stresses in the PCM container below the yielding point.
The Dewar refrigeration system consists of a newly designed Dewar interfaced with a cryocooler capable of obtaining temperatures below the vaporization point of liquid helium.
The proximal centralizer was custom designed to fit the medial part of the stem just below the meeting point between the neck and the body of the prosthesis.
