Sentence examples for behaviour of additives from inspiring English sources
In this project, the fate in and after the use phase and also the behaviour of additives in the following six sectors were investigated in detail: textile, electronics, plastics, leather, paper and lubricants industry.
Four types of via-filling models are developed in this paper, considering distinct chemical behaviour of additives used in the TSV electroplating.
RISKCYCLE focused on the fate and behaviour of these additives in six sectors: textile, electronics, plastics, leather, paper and lubricants.
Hence the underpotential deposition of Cu can be used to monitor the adsorption behaviour of the additives.
The behaviour of the additives Al2O3 and Y2O3 on the microstructure of Si3N4 and Si3N4ZrO2 doped materials was studied using couple diffusion systems (Si3N4Al2O3/Si3N4Y2O3).
These three opaque hues are the subtractive pigment primaries and should not be confused with the behaviour of the additive triads and mixtures of transparent, coloured light.
The structural behaviour of PBF additive manufactured cross-sections was investigated through a series of square hollow section (SHS) stub column tests, and the results compared with conventionally produced stainless steel SHS.
In fact, the adsorption behaviour of the TBP and NMBI additives on TiO2 could be differentiated by the small-sized titania nanoparticles (produced following the TiCl4 treatment), thus affecting in a different way the electron injection/recombination dynamics.
The behaviour of low profile additive (LPA) could be modified by adding a thermo-breakable functional group to its molecule.
Results showed that the additives might alter the oxidative state of the binder, the chemical additive is able to modify the tribological behaviour of the binder, the wax additive acts solely on the viscosity and the effect of the additive depends on the chemical composition of the base binder.
There are, however, limited available experimental data on the material behaviour of powder bed fusion (PBF) additive manufactured metallic structural elements and no existing data at the cross-section level; this is addressed in the present paper through a series of tests on additive manufactured stainless steel material and cross-sections.
