Sentence examples for before threshold from inspiring English sources

Test results show a pixel cell noise of about 110 electrons rms and a mean minimum threshold of about 1000 electrons rms before threshold fine tuning.

It is found that scaling limits are reached sooner by Tunnel FETs with an SiO2 gate dielectric, while those with a high-K dielectric can be scaled further before threshold voltage, and average and point subthreshold swing are affected.

Immediately before threshold evaluation, untreated hypertensive patients had higher than normal blood pressure levels, while hypertensive patients under treatment, headache patients without hypertension and control subjects had normal blood pressure values.

The threshold for spike detection was set to −4.5 SD (standard deviations) and the spike waveforms were measured in a time window 1400 μs long and beginning 150 μs before threshold crossing.

The paper primarily focuses on the role of the "action" on the reliability, that is the current delivered over some time interval, concluding that a sharp increase in action just before threshold is key to generating reliable spike-evoking epochs (SEEs).

In this case, a possible optimal strategy would be the threshold kick strategy, defined by giving the initial kick of size γ c and following this with a kick of size G − γ c just before threshold crossing occurs (Figure 1).

The electron spectra were registered also at the before-threshold values of beam current density (less than 0.1 А/mm2) which have not resulted in a sudden degradation of the ceramic grain coagula.

A presentable segment of large asymmetrical coagulum covered by the amorphous-like shell for the (Bi1 − x Pb x )2Sr2Ca2Cu3O y ceramics (SEI): a fresh surface; b this surface after before-threshold electron beam exposition within 22 h (E e = 5 keV; i = 0.08 А/mm2, RT); (1) to (3) were three microzones for local Auger analysis.

As before, the threshold structure remained unchanged.

Note that at very low SNR, H k must be first order low-pass filtered before thresholding, in order to eliminate most false alarms.

Boundary conditions are issues of LP implementation, i.e., small R x values before thresholding (for sign operator, values are close to zero).