It has been shown that depending on the particular fingerprints used, the outcome of similarity searching [2] or activity landscapes [3] can be very different.
It has been shown that depending on the location of the concentrated mass, the inclusion of its rotary inertia may either decrease or increase the natural frequencies of the resonator compared with the case of no rotary inertia is included.
It has been shown that depending upon actual arrangement of the hybrid nanostructure, it is possible to obtain strong enhancement of the absorption rate [4] or increase of the fluorescence rate [5] in such a system.
Thus, it has been shown that, depending on the composition of the film, the fatigue life of the steel can be increased between 566 and 1677% and the fatigue limit can also be increased between 9.1 and 10.8%.
Different types of graphene/elastomer nanocomposites are described in terms of their manufacture and properties and it has been shown that depending on the type of graphene employed and the preparation methods, the mechanical, thermal, electrical and barrier properties of the elastomeric matrix can be enhanced due to the presence of graphene, even at relatively-low filler loadings.
Thus, it has been shown that, depending on the maximum alternating stress applied to the material, the fatigue life of the steel can be increased between 400 and 2119%, whereas the fatigue limit was observed to increase by 22%, that is to say, 60 MPa above the fatigue limit of the uncoated substrate, which in the present work was found to be of approximately 381 MPa.
We first investigate the behavior of known independent component analysis (ICA) methods in the case where the independence assumption is violated: specific dependent sources are introduced and it is shown that, depending on the source vector, the separation may be successful or not.
It is shown that, depending on the geometrical shape, the system can be stiff.
It was shown that depending on the faunal component used as a bioindicator, different results can be observed.
It is shown that depending on the attitude of the decision-maker towards uncertainty, the optimal design can change significantly.
It is shown that depending on the anisotropic strength, one gets different dynamics of adsorbate island growth.
