Currently, the coating is applied using two different methods: electrodeposition and gas dynamic cold spray.
The model was applied using two approaches: logistic-BRT as an indirect approach and multiclass-BRT as a direct approach to produce soil class maps.
Full factorial 32 design was applied using two independent variables viz., X1: Drug to total lipid ratio and X2: Surfactant concentration whereby their effect on dependent variables viz., Y1: Size, Y2: PDI and Y3: %EE was studied.
A simultaneous dual-sheet Rayleigh/OH-LIPF measurement technique was applied using two parallel laser light sheets to measure the temperature in the preheat zone for three lean (ϕ=0.7) turbulent methane/air flames.
To investigate the influence of the deposition process, the MCrAlY bond coats were applied using two different spraying processes, high velocity oxygen fuel spraying (HVOF) and low-pressure plasma spraying (LPPS).
The methodology proposed by Civet and Tarits (2013) and summarized in Additional file 1 was applied using two different proxies representative of the temporal variability of the EM source.
The adhesive system, Adper Single Bond 2 (3 M/ESPE – St . Paul Mn, USA), was applied using two consecutive coats, gentle air-dried for 5 s, and light cured for 10 s with a halogen light (Optilux – Kerr Dental, Orange, CA, USA), with an intensity of 600 measuredmeasured with the SDS radiometer (Kerr Dental, Orange, CA, USA).
Before injections, echographic gel was applied, transcutaneous electric pulses were applied using two custom-made stainless steel plate electrodes placed on either side of the xenograft as previously described (Takei et al., 2008).
A gradient was applied using two solvents.
The same procedure was applied using two other published filtering methods.
