Sentence examples for bed inclination from inspiring English sources

The results indicate that bed inclination creates short circuits for the gas phase along the upper wall where it can flow in a segregated manner.

Based on the experimental observations and quantitative data obtained (mainly the time variation of bed inclination angle), a simple empirical approach to predict the self-leveling development depending on particle size, particle density and gas velocity was proposed.

The performance of Fischer-Tropsch synthesis in the presence of water-gas shift reaction increases slightly with amplification of packed bed inclination even if the distortion of axial symmetry of liquid holdup and axial velocity radial distributions becomes considerable.

Development of gas-liquid disengagement zones, oscillations in the pressure drop and uniformity factor time series, departure from liquid plug flow character, and delay in the inception of pulsing flow regime were observed as a result of bed inclination and oscillations.

It was stated that for the generation of fresh water the design parameters i.e. height of glass from the desiccant material bed, inclination in angle, effective thickness of glass and number of glazing are 0.22 m, 30º, 3 mm and single respectively.

This article studied the restrictive effect of geological and mining factors, such as lithological properties of roof strata, coal seam inclination, water source to bed separations, roof management method, dimensions of mining working face, and mining progress, on the formation of bed-separation water hazard.

The design parameters for the water production are height of glass from desiccant bed at 0.22 m, inclination in angle at 30°, effective thickness of glass at 3 mm and number of glazing as single.

Design parameters for water generation are height of glass from the desiccant material bed as 0.22 m, inclination in angle as 30º, the effective thickness of glass as 3 mm and number of glazing as single.

In particular, in the lower pipe rotation speeds, the cuttings volume in the annulus is more for lower inclinations than for higher inclinations, which means that cuttings bed is easier to be formed in the low inclination.

It is shown that this loss can be compensated by modulating the local bed height via a moderate inclination of the bed support.

The main influencing parameters are the increment of superficial gas velocity, installation height, inclination angle, static bed height, and installation method of the slat.