Sentence examples for because the peak at from inspiring English sources

As shown in Figure 3, Al-MCM-48 has weak acidity because the peak at approximately 220°C was attributed to NH3 desorption from the weak acid.

Because the peak at ~1075 cm −1 shows the highest intensity, this peak was used to compare the SERS intensities of Raw264.7 cells treated with LPS at different incubation times and those of untreated cells (Fig. 4b).

Because the peak at 1.5 ppm has a negative PC1 loading, it is enhanced in the whole, acid-insoluble, and acid-soluble samples (as they have negative PC1 scores).

This can by calculated from 129Xe spectra because the peak at 218 ppm is uniquely attributable to 129Xe in red blood cells, and the size of this peak, relative to the membrane tissue/plasma peak (197 ppm), is determined by the relative 129Xe solubility and the pulmonary hematocrit.

However, the deacylation rate is much slower than that for sulbactam because the peak at 1780 cm 1 that represents C=O stretch in the intact β-lactam ring is still evident at 23 ms and to a small extent at 5 s.

Heating eliminates organics residues, because the peaks at 3400 cm−1 appear as a shoulder superimposed on the O H band.

Because the peaks at 2.5 ppm and 4.2 ppm overlap with resonance peaks of other compounds in the fermentation broth, we only integrate peak area of the double peak located at 1.2 ppm to quantify the concentration of 3-HB. Figure 2 Proton NMR spectrum of reagent 3-HB.

FT-IR analysis was performed to verify the existence of PI in the composite films as shown in Figure 5b, and it was confirmed that PI exists in the composite films because the peaks at 1,722 cm−1 of the composite films were assigned to C = O stretching vibrations.

Although the presence of PMMA was confirmed in composite films, since the peaks at 1,730 cm−1 of the composite films were assigned to C = O stretching vibrations, it was considered that these PMMA components were present in small quantities because of the low intensity of the peak at 1,730 cm−1.

Perhaps it refers to the low concentration of the nanoparticles because the peak centered at 530 nm will obviously become sharp as a result of the increased quantity of nanoparticles.

When there is a single discrete pulse, the best PAPR reduction performance can be obtained because the maximal peak at location can be canceled without distorting other signal samplings.