Sentence examples for because in the simulation from inspiring English sources

This is because, in the simulation data set, the phenotype was measured at ten time points.

Furthermore, the performance gets worse with LL-ARQ as the burstiness gets higher because, in the simulation environment considered, TCP performance is more sensitive to RTT increase rather than PER decrease due to LL-ARQ.

This is because in the simulation process of AWORS, there were very rare cases where the accumulated water surpassed B, even when it as set at a low value.

This is because in the simulation scenario all UE are dropped within a radius of 60 m around the picocell, so that many macrocell UE are close to the picocell and suffer from intercell interference.

This is because in the simulation (and in our case study data upon which the simulation is based), the range of expression differences in sporadic genes is smaller, in general, than in dynamic genes.

The average of the PSI and GSI selection responses values for all cycles, and the average of the PSI and GSI expected genetic gains per selection cycle for all cycles for observed and unobserved traits, respectively, were very similar when their generation interval was ignored because in the simulation process 95% of the QTL were in linkage disequilibrium with markers.

This is because, in our simulation, the user 3 has the best channel condition so that it can achieve higher sum rate.

When studying the behaviour of the network using TCP traffic instead we observe that the average throughput is not increased because, in both simulations, the network is saturated.

This phenomenon occurs because in our simulation, when α decreases, the SNR for a given β increases, counterbalancing the negative effect of the transfer function miss-specification.

Note that in this figure, we do not list the performance of Comb-type I because it failed in the simulation.

In Figure 2, there are a few differences because the nanofluid in the simulation is supposed as a single phase, while the real nanofluid is a two-phase fluid.