Sentence examples for beam heating from inspiring English sources
The erosion of Be-, C- and W-atoms and their ionization in SOL and the multi-fluid transport in the confinement region are calculated for the whole ITER deuterium discharge with neutral beam heating.
It is suggested that these morphological changes in nanorod may have happened due to the compression which was generated either by shrinkage of tube or by local electron beam heating.
During the KSTAR 2010 campaign, a MW-deuterium neutral beam was successfully injected to the KSTAR plasma with maximum beam energy of 90 keV and the L-H transition was observed with neutral beam heating.
The aim of the JET ITER-like wall project was to provide JET with the plasma facing material combination now selected for the DT phase of ITER (bulk beryllium main chamber limiters and a full tungsten divertor) and, in conjunction with the upgraded neutral beam heating system, to achieve ITER relevant conditions.
The electrochemical properties of low-index phase Rh(1 1 1), Rh(1 1 0) and Rh(1 0 0) single crystal bead electrodes, prepared by a novel technique combining electron beam heating with inductive annealing in a controlled atmosphere, have been characterized in 0.1 M H2SO4 by cyclic voltammetry and chronoamperometry.
A 60-nm-thick SiO2 was evaporated by means of electron beam heating onto the top surface of now N+ Si emitter for surface passivation [7] in a home-made vacuum chamber with a base pressure less than 1 × 10−4 Pa.
Neutronics calculations are performed with the MCNP5 neutron transport code for the KSTAR neutral beam heated deuterium plasma discharges.
The beam heats the plasma to fusion temperatures and also generates fusions in its initial collision with the hot gas.
Delgado-Aparicio, L; Stutman, D; Tritz, K; Finkenthal, M; Kaye, S; Bell, R Kaita, R Leblancnc, B; Levinton, F; Menard, J; Paul, S; Smith, D; Yuh, H, Impurity transport studies in NSTX neutral beam heated H-mode plasmas, Nuclear Fusion, vol. 49 no.
In this type of pump, titanium is sublimed onto the pump walls from either a resistance or an electron-beam heated source.
It is shown that the EC4 predictions are generally conservative for the design of composite slim floor steel beams heated using different fire scenarios.
