Sentence examples for beam flanges were used from inspiring English sources
In the first detail, two integrated vertical plates which are placed next to the column flanges and welded to the column flanges' edges and beam flanges were used in order to connect the two channel-section beams to the column.
In the second detail, four vertical trapezoidal plates which are welded to the edges of the column flanges and beam flanges were used in order to connect the two I-section beams to the column.
A plastic-and-rubber flange is used to seal around penetrations such as plumbing vents.
Two steel wide flange beams were used with two steel double channel beams to anchor the repaired column specimens (Fig. 3c, d).
Initially, data from a rigid beam to column flange connection were used to verify numerical analysis and result, owing to the unavailability of experimental data concerning rigid beam to web connections.
Cold-formed lipped channel beams (LCB), LiteSteel Beams (LSB) and Triangular Hollow Flange Beams (THFB) are commonly used as flexural members such as floor joists and bearers while Rectangular Hollow Flange Beams (RHFB) are used in small scale housing developments through to large building structures.
Three 20-mm diameter austenitic stainless steel bolts in property class 80 were used through the beam web and six 20-mm diameter ordinary bolts in grade 8.8 were connected to the column flange (the reason that grade 8.8 bolts were used in the flange is because the failure mode in earlier tests (Yu et al. 2009) was in the bolts in the beam web, that is, the column flange bolts were not critical).
The regions of the beams with negligible bending moments, i.e. at the vicinities of the supports (pin-rolled), were used and the stainless steel was bonded at the bottom region of the flange of the T-beam with their ends free of any additional mechanical anchorages.
Beams with corrugated webs and flat plate flanges have been used in buildings around the world for many years.
Parallel wide flange steel profiles, usually beams, are used as transverse stiffeners that are spaced perpendicular to the longitudinal axis of duct.
