Sentence examples for be suitable for comparison from inspiring English sources

The control population we do have comes exclusively from the National Capital Area and would not be suitable for comparison.

Around 120,000 samples were taken in smaller water bodies (FLOZ 1 3) representing edge of the field water bodies and are judged to be suitable for comparison to the RAC obtained under the Swiss pesticide regulation [23].

Yoshida et al. (2011) derived a slip distribution during the 2011 main-shock from teleseismic P-waves and regional strong motion data, and the results of Yoshida et al. (2011) are considered to be suitable for comparison with the aftershock distribution, because the slip distribution using strong motion data should correspond with the radiation of seismic waves.

However, these norms were obtained by postal questionnaire only, and may therefore not be suitable for comparison in studies using telephone interviews.

Figure 7 illustrates the type of data available that would be suitable for comparison to the simulated results and allow for a tuning of parameters to more closely reflect actual data collected concerning a particular disease [ 10].

Preliminary power analysis based on the expected prevalence of hand OA indicated that a sample of approximately 400 individuals would be suitable for comparison of photography and radiography for the diagnosis of hand OA.

In order to be suitable for comparisons with new data sets, these transcription profiles have to consist of quantitative values stored in a digital form and allowing for normalization procedures compensating for differences in the efficiency of mRNA extraction, cDNA synthesis and detection.

Shot 2 was located close to the ACROSS source site and is suitable for comparison.

Comparable Data collection should be standardized so the results are suitable for comparison between various jurisdictions, times and groups.

By analyzing these two performance metrics, we can determine whether or not our baseline system is suitable for comparison purposes.

It should be noted that since this method is based on sparse representation but uses MSE-based criteria, it is suitable for comparison.  .