Sentence examples for be revised to be from inspiring English sources
The phrase "be revised to be" is correct and usable in written English.
It can be used when indicating that something should be changed or updated to a specific state or condition.
Example: "The document should be revised to be more concise and clear for the audience."
Alternatives: "be updated to" or "be modified to".
DENVER — A sweeping anti-abortion statute in Utah that would have allowed up to life in prison for a woman whose fetus died from her intentional or reckless behavior was withdrawn by its sponsor on Thursday and will be revised to be narrower in scope.
And on Friday, an S.E.C. commissioner, Luis A. Aguilar, told a group of securities lawyers that a recent attempt to tighten the agency's policy of allowing a company to settle a fraud case while neither admitting nor denying any wrongdoing "applies in so few situations, it needs to be revised to be more useful and effective".
Overall, the data suggest conceptualizations of pathological social anxiety may need to be revised to be useful for studying individuals in East Asian cultures.
There is an important issue that should be concerned with filtered output after filtering by vector F. Since m+n-1 dimension is much longer than m, the length of filtered output must be revised to be consistent with original response A. For filtered output, the points at two sides can be abandoned because their values are so little that hardly include useful information after sidelobe suppression.
Further, how might end-of-semester course evaluations be revised to be more learner centered?
The title should be revised to be informative and consistent with the contents of the paper.
Her classmate, Jenna Adymy, is less enthusiastic because of the changes in campus policies affecting parking and visitation, which are being revised to be consistent with the residential life policies at Fordham.
The item was revised to be inclusive of both male and female preferences for gender of health care provider.
Asperity II of the slip model was revised to be less severe so that the simulated and observed waveforms and PGA were well matched.
On March 13, Mw was revised to be 9.0 by CMT analysis using a longer range of filter (Hirose et al., 2011).
The interfaces between the BLV and the Beam Line Components (BLCs) have been revised to be compatible with the new vessel design and the BLCs support frames.
