To set the scale, we have expressed the copy number as a fraction of its maximum possible mean value, g0, which is reached at high concentrations of the transcriptional activator.
With this configuration, a better accuracy is reached at higher frequencies up to 1 MHz.
Similar phenomenon is observed regarding the orientation within the film plane of the PA6 chains in the strain-induced α-crystals, i.e. equivalent chain orientation is reached at higher strains in the multilayers.
Recovery experiments for a milk standard reference material diluted in water-soluble tertiary amines in both robust and non-robust conditions indicated that the robust condition was reached at higher nebulizer gas flow-rates and led to better accuracy and precision when using a V-groove nebulizer.
Quantitative evaluation by trichroic infrared analysis of the various crystal forms of the PA6 component shows that the strain-induced β α crystalline phase transition is delayed in the multilayers, i.e. equivalent level of phase transformation is reached at higher strains.
Increasing δ, outage saturation is reached at higher (bar gamma _{12}).
However, as the catalyst temperature in the experiments decreased with increasing methane feed gas concentration, higher carbon dioxide conversions were reached at higher methane concentrations.
The MDC for LNCaP cells incubated as spheroids (Fig. 2b), is reached at higher cellular number 1.52 × 103, 3.2 × 104, 5 × 104, and 1.3 × 105, but at lower background levels of 0, 10, 50, and 100 Bq/ml, respectively.
As the figure shows, an earlier breakthrough point was reached at higher concentration (100 mg L−1), where the adsorbent was exhausted faster as compared to the lowest concentration (40 mg L−1).
After a sharp increase in adsorbed swollenin at low concentrations, a plateau was reached at higher concentrations (> 5 μmol/L).
