Sentence examples for be optimal to evaluate from inspiring English sources

Ideally, direct comparison of values for the same mice evaluated at both the acute and recovery time points would be optimal to evaluate changes longitudinally, which was not done with this recovery cohort.

It may be optimal to evaluate relatives for constitutional MLH1 hypermethylation and to follow any who manifest this phenotype under a research protocol, as if they may have risks akin to those reported in Lynch syndrome.

The hydrophobic properties of fine materials could be determined not only by measuring the contact angles [44, 45] but also by using a calorimetric technique to determine the heat of immersion in polar and nonpolar liquids [46, 47], and this method is optimal to evaluate the hydrophobicity of powder materials.

While an experimental design would have been optimal to evaluate the research question, it cannot be envisaged in the current cancer services, as the majority of local programs promote and support interdisciplinary team work.

Our studies demonstrate that laser power of 950 1500 mW and angiography analysis 4 weeks post-laser are optimal parameters to evaluate treatment effects on CNV induction following laser photocoagulation.

3′ UTRs were folded locally using RNAplfold (Bernhart et al., 2006), allowing the maximal span of a base pair to be 40 nucleotides, and averaging pair probabilities over an 80 nt window (parameters -L 40 -W 80), parameters found to be optimal when evaluating siRNA efficacy (Tafer et al., 2008).

In present investigation formulation F6 with drug/polymer ratio (1 100) was found to be optimal in terms of evaluated parameters where it showed a significantly higher percentage of encapsulation efficiency (76.84%) with minimal drug release (3.25%) in an acidic environment.

Therefore, DNA methylation levels at appropriate marker CpG sites would appear to be optimal prognostic indicators if evaluated quantitatively [ 27].

The results can be used to evaluate optimal tracking performance and control energy in practical designs.

Optimum (P_{T}^), obtained using OPA, can be used to evaluate the optimal source power allocation (OSA) (i.e., (P_{T_{1}}^), (P_{T_{2}}^)) under the condition of fixed relay power (P R ) and position ((d_{T_{1}R}), (d_{T_{2}R})).

Direct observation of teaching practices is optimal for evaluating the efficacy of professional development programs.