Sentence examples for be low enough so from inspiring English sources

The isopiestic experiments on the dilute solutions are very important, and the lowest molality should be low enough so that a theoretical method can be used below the lowest molality.

The MPCR is usually specified to be low enough so that it is individually optimal to contribute nothing, but high enough so that it is socially optimal to contribute fully.

2. Stir in garlic and 1/4 teaspoon each of salt and pepper, and cook until garlic is fragrant and fish is just cooked through, another 3 minutes or so (heat should be low enough so as not to brown the garlic or fish but high enough to gently cook everything; the cooking time will vary widely with your stove).

Firstly, the strength of the basal fault in the source zone had to be low enough so that all the material vacated the planar rupture surface.

For employers to be indifferent between hiring an inexperienced worker i and a experienced worker for job j, the wage w i needs to be low enough so that the following equality holds: y i H ij − w i + α j q j G > q j G − w j + α j q j G (4).

The dynamic and unpredictable behavior of the licensed channel vacuity forces to set an irregular transmit power profile for the opportunistic resources allocated to each user depending on its distance from the licensed system-power must be low enough so as not to interfere with the primary system.

The maximum embedment depth obtained for all surfaces was low enough so that it did not cause plastic deformation on the surface.

We assume that the temperature is low enough so that the reactive flux focuses around a finite number of paths connecting the reactant and the product states.

Kids could dig it and, if the volume was low enough, so could the older, less web-savvy people they were trying to sell IE9 to (it's presented as a browser even Prince Philip could get his head around).

The maximum values of the amplitude are constrained by the laminar-turbulent transition criteria, and the limiting amplitudes of the laminar state of the motion are low enough so that only weakly non-linear effects are caused for which the perturbation method can be used.

This is true only when the packet generation rate is low enough so that no more than one packet is generated during a period (see Figure 5).