Sentence examples for be kept at lower from inspiring English sources

However, the filter would be plugged with particles to cause an increase of filter back-pressure, which must be kept at lower levels, because the higher back-pressure increases fuel consumption and reduces available torque.

Particularly, the buffer occupancy for the EF traffic class is kept at lower levels, being able to reach 90 packets only during the minimum value of the bandwidth reduction (750-time point).

It has been proved that the conventional outage probability cannot convey the primary design consideration of this decoupled architecture that C-plane more heavily affects the entire transmission reliability than U-plane thereby being kept at lower frequency bands.

In this study, most genes in the flagellar/chemotaxis cluster were down-regulated by 2- to 4-fold at the onset of sporulation and were kept at lower expression levels thereafter.

The goal would be to make the immune system so effective that the virus would be kept at even lower levels and suppressed for even longer times.

Glucose concentration in the fermentation broth should be kept at a lower level (less than 20 g/L) to eliminate its deleterious influence on ethanol flux and membrane selectivity.

A surprising scale effect related to the ratio of widths of SS and SM interfaces is found: it suppresses barrierless IMs but allows IMs to be kept at much lower temperatures even for kE<2.

However, the conclusions towards optimization of operating conditions, in most cases, were as follows: (1) process duration could be shortened, (2) flow rate should be kept at the lower boundary and (3) transmembrane pressure should be kept at the upper boundary of the investigated experimental space.

Various types of IM are found: (i) continuous and reversible premelting and melting; (ii) jump-like barrierless transformation to IMs, which can be kept at much lower temperature even for kE<2; (iii) unstable IMs, i.e. a critical nucleus between the SS interface and the IM.

These results indicate that nitrogen injection should be kept at the lower ranges that are studied.

The wear rate of wheel was also significantly minimized and Ft/Fn ratio could be kept at steady and lower level, which depict the better sharpness retention of grits under nano-SQCL environment.