Sentence examples for be incorporated at low from inspiring English sources

CenH3 can be incorporated at low levels into nucleosomes away from the centromeres (Camahort et al., 2009; Lefrancois et al., 2009; Lopes da Rosa et al., 2011; Krassovsky et al., 2012; Lefrancois et al., 2013; Lacoste et al., 2014), and so the presence of cenH3 itself is thus not a sufficient measure for the presence of a centromere.

Single-walled carbon nanotubes (SWCNTs) were incorporated at low loading (up to ∼1 wt%) into an unfilled aerospace-grade epoxy system, to impart electrical conductivity while maintaining structural bonding capability, as a route for development of a structural and conductive adhesive.

In this sense, the heat-up synthesis where Mn dopants may be incorporated at high concentrations (initially at low temperatures) presents a potential system where Mn dopant loss may be beneficial.

During preparation of the liposomes, the fluorescent molecules N-NBD-PE (donor) and RH-PE (acceptor) are incorporated at a low molar ratio (1% mol/mol of both NBD-PE and RH-PE) in the vesicle bilayer.

This suggests that once H3.3 is incorporated at silenced genes, it is stably maintained and shows low dissociation rates.

2-AAF was incorporated at 0.02% in the pellet chow.

Labels were incorporated at the stage of cDNA synthesis.

Most significant is that pyridinic defects are relatively readily incorporated at low nitrogen doping levels while at nitrogen content higher than 5% the major incorporation mechanism is dominated by pyridinic and pyrrolic defects on an equal basis.

Moreover, no bismuth is observed to be incorporated in the subsequent 5-nm GaAs grown at low temperature while a As/Ga stoechiometric ratio was still being used.

Both MobileWise and Splashpower say that their recharging adapters can be incorporated into existing designs with very little modification, and at low cost.

In order to ascertain the effectiveness of the quenching mechanism and its inter-relationship with carbon black parameters, a total of eight different carbon black pigments have been incorporated into low density polyethylene at different concentrations (0.1, 0.2, 0.4% w/w) and their effects determined on the quenching the triplet state of a known triplet photosensitiser, benzophenone (0.05% w/w).