Finally, the cross-plots between cost function values and the selected parameter were created as shown in Fig. 3.
The following widgets are created, as shown in Fig. 2: (a) Plan view: to show the layout of furniture and the position of the user.
To improve the efficiency of calculation, three-dimensional mesh models of the isolation tool and pipe were created, as shown in Fig. 7.
When two synsets are equal, the concepts are mapped between the ontologies, i.e., for each concept of an ontology that is found in the personomy ontology, a mapping relation between them is created, as shown in Fig. 5.
Once discovered features are reviewed and engineered, a final set of features consisting of the union of medical expert feature selection and algorithmic feature selection is created (as shown in the equation below).
The supervisory control and data acquisition (SCADA) is used to acquire water level variation information of the reservoir based on the head at the reservoir H st, and HGL multiplier at time t was created as shown in Table 1.
Corresponding to Figure 2a,c, the dislocations generated from the InAs/Si interface were trapped, and thus, an almost etching-pit-free surface was created, as shown in Figure 4a,b.
Three created structures, one for each capture method and a skeleton artifact template for CV4L2Source along with the Cleanup method are created as shown by Listings Listing 7 Data type definition for the capture mode and Listing 8 class claskeletonton artifact template code, respectively.
The SubVI of the source nodes is created, as shown in the block diagram given in Fig. 4. The signals are then transmitted through the antenna by using the RF front ends of the USRP modules, controlled through the USRP VI from the USRP TX Library.
