Sentence examples for be constrained at the from inspiring English sources

These layers may either be constrained at the lower interface or coupled to an elastic half-space.

Based on early estimates of the mutation rate in humans and the size of the human genome, simple calculations done decades ago showed that only a small fraction of it could be constrained at the sequence level, otherwise there would be too many deleterious mutations in every generation for the species to survive (Ohno 1972).

And growth in the sector is constrained, at the moment, by transmission.

Migration to the Sunbelt is therefore failing to raise productivity in tradable sectors to a level sufficient to justify new hiring at prevailing wage rates.The picture that emerges is one in which employment growth in high productivity, tradable industries is constrained at the rate of housing supply growth in skilled cities.

Livestock in all other nations of the world are constrained at the national level only.

Bending deflection and stress distribution were analyzed when the thermal expansion was constrained at the edge of the first wall.

This simplification is reasonable due to the fact that the rotations are constrained at the ends of the columns by beams in tension (Ghali et al. 2003).

In a March 23 note Reitzes wrote that during a visit with Asian companies, BarCap learned that iPad yields should improve dramatically through 2010, even if capacity is constrained at the initial launch.

As a result, when the LCE sample is constrained at the two boundaries, the small deflection bending theory is no longer applicable, and we need to use the large deflection theory.

Under high wind speed conditions when rotor speed is constrained at the rated value, additional power provision can be fulfilled through pitch angle control to emulate an inertial response if temporary over-loading is allowed.

The almost concurrent drop in tip etch rate and jump in base etch rate at around χ = 0.85 means that holes and Ag+ ions that previously diffused away from the etching front at lower χ values were now being constrained at the base due to the inhibition of oxide formation at the Ag Si interface.