It can be concluded that among the evaluated techniques the strain energy method presents the best stability regarding noisy signals; however, the detection judgement depends on a threshold level which is discussed in this paper.
It can be concluded that among the systems evaluated, the Guelph-L at an inflow-rate of 12 L min−1 was most efficient for both solids removal and water velocity profile and thus seemed more suitable for shrimp digestibility studies in high performance conditions.
Finally, it can be concluded that among the employed EBR samples, EBR30 showed a better improvement in the physico-mechanical properties while using as a compatibilizer in the SBR/BR silica composites.
Comparing all the data obtained from the analysis, it can be concluded that among all storage parameters, high temperature and air exposure were the two strong factors in fastening the Jatropha biodiesel degradation.
Based on the above experimental findings, it can be concluded that among the studied three modifiers, NH4BF4, (NH4 2SiF6, and NH4F, NH4BF4 performs the best in the modification of alumina surface acidity because of the synergistic effect of F and B in the generation of Brönsted acid sites and the reduction of Lewis acid sites.
It can be seen that the ductility of the columns with larger aspect ratio is higher, and considering the smooth trend of data in Fig. 15g, it can be concluded that among the three parameters, diameter, height and aspect ratio, only the aspect ratio needs to be considered for ductility evaluation.
It can be concluded that utilization of oral health services among children and adolescents is low to medium, and irregular.
It was concluded that among the chemical admixtures used, the superplasticizer (SP) significantly increased the workability of SPC.
It was concluded that among the mineral admixtures used, FA and GBSF significantly increased the workability of SCC.
It was concluded that among the mineral additives used, fly ash and limestone powder significantly increased the workability of SCMs.
It is concluded that among various kinds of numerical solution methods we can usually find most adequate ones for the present problem.
