Although heat transfer effect had not been considered, it was concluded from analysis of FT rate that to control the reactor temperature, appropriate heat removal devices are required next to the gas injection region when the syngas flow rate is low.
It was concluded from analysis of autoradiography images which show a higher accumulation of I-avidin in pretargeted compared to non-targeted tissue.
It can be concluded from the analysis that, during seismic response, the tensile stress is the control stress in the design and seismic safety evaluation of concrete dams.
It can be concluded from the analysis of the results on Table 2 that the M06, M06L, M06-2X and M06-HF density functionals predict that C10 will be the preferred site for nucleophilic attack.
It may be concluded from the analysis of the interviews with experienced VET teachers that their work has been affected by the changes that have taken place at different levels within the VET system in Estonia.
It can be concluded from failure analysis that dike failures on the landward slope are rather initiated by individual overtopping events, in particular by the related overtopping flow velocities and layer thicknesses which are relevant for the prediction of erosion, infiltration and slip failure.
We want to stress that nonpathogenicity cannot be concluded from the analysis of a genome sequence.
Two key aspects can be concluded from our analysis: First, due to the diversity in methodology, quality-adjusted life years calculated in different studies are not comparable and compatible with each other.
What can be concluded from this simple analysis is that the two libraries seem fairly complementary, with some properties showing different distributions.
It can be concluded from above results analysis that B-type modified asphalt binder has better viscosity balance with the viscosity modifiers regarding 60 °C high dynamic viscosity.
It can be concluded from the experimental analysis that built orientation has significant affect on the tensile, flexural and total cost of the FDM parts.
