It is shown that, above about 1000 K, ignition delay times for propane and all higher alkanes, as well as for a number of other fuels, can be calculated well by employing rate parameters of only three types of elementary steps, namely CmHn + HO2 → CmHn−1 + H2O2, H2O2 + M→2OH + M and 2HO2 → H2O2 + O2, only the first of which is fuel specific, the other two clearly being common to all fuels.
"It was calculated, well conceived, the result of numerous conversations".
Similarly, the received SNR at the eavesdropper can be calculated as well by simply replacing γ r m d in (1) by γ r m e, where γ r m e = P | h r m e | 2 / N 0 is the instantaneous SNR of the link R m → D.
For many practical problems, the induced stresses can be calculated relatively well by means of existing analytical, numerical and experimental methods.
The discrete dimensional fluxes can be calculated as well "horizontally", i.e., by adding function values along the M[HS] kxn submatrix series.
But it seems like it could be calculated as well.
The inset of Fig. 3a shows the on/off ratio of the ZnO NR-based NUV PDs grown at 25 mM as a function of W ch. The on/off ratio can be calculated by the well-known equation of R = (I photo − I dark)/I dark.
Both t scores and z scores can be calculated manually, as well as by using a graphing calculator or statistical tables, which are frequently found in statistical textbooks.
This indicated that for a given measured fall, ΔHw, for a particular head of water, Hw, in a well, Kfs could be calculated by dividing the parameter Kfs × Δt, by the observed time, Δt, for the fall, ΔHw, to occur.
The number of neutrophils adhered per well can be calculated by knowing the amount of chromium-51 incorporated into neutrophils.
With the full knowledge of fluctuation of groundwater level, the hydraulic conductivity/filtration conditions can be calculated by analyzing recession curve of well hydrograph (Ferdowsian et al. 2001; Gailuma and Vitola 2009; Posavec et al. 2006; Sujono et al. 2004).
