Sentence examples for be calculated using existing from inspiring English sources

This has to be calculated using existing knowledge about the architecture of the system and the probability of component failure.

Next, from the definition of specific force we analyze the causing reason of sculling error effect, and without changing the analytical expression we determine a reasonable correcting measure in which sculling error can be calculated using existing algorithm.

A mapping algorithm for the two instruments allows values for EQ-5D-5L stotes to be calculated using existing EQ-5D-3L value sets [ 6].

Finally, based on the assessments in the first two steps, the magnitude of accessibility problems caused by a particular combination of functional limitations, dependence on MDs, and environmental barriers can be calculated using existing algorithms.

Average time spent per day in moderate to vigorous physical activity (≥ 3.0 MET) was calculated using existing age specific cut points for accelerometer activity counts [ 29].

IWF President Carrie Lukas points out that under the IWF plan, maternity leave pay would be calculated using the existing Social Security disability benefit formula, which means that lower-income mothers would receive a greater rate of income replacement than high income ones.

The proposed mitigation solution is obtained by a stochastic model which assigns satellite and epoch-specific weights based on the inverse of the variances of the output error of the GPS receiver DLL and PLL, which can be calculated using the existing tracking models (Conker et al. 2003).

Evidence from the literature and clinical expertise contributed to the refinement of these models, with the goal of a predictive scale that could be calculated using an existing MDS assessment, but also could be readily done at the bedside prior to completion of the full set of MDS items by admission day 14, or prior to a scheduled MDS reassessment.

The third component of the index is akin to indices of reproductive skew (Sherman et al. 1995; Nonacs 2000) and could thus be calculated using one of several existing formulas, as long as they yield estimates ranging between 0 and 1 (see Nonacs 2000; for a review of proposed indices).

We perform an analysis of the proposed sphere fitting method and we verify that the obtained results are comparable to results calculated using existing techniques.

A comparison between the shrinkage strain obtained experimentally and that calculated using existing models for predicting shrinkage is also presented.